MATRIX VISION - mvBlueFOX Technical Documentation
Connecting The Camera
Note
Before connecting the mvBlueFOX, please install the software and driver first!

After the driver installation you have to connect the mvBlueFOX using a USB 2.0 cable.

You can check if the driver installation was successful by using mvDeviceConfigure. Supported device with an installed and running driver should be listed:

Connected mvBlueFOX

Afterwards, you can start wxPropView to configure the mvBlueFOX.

Since driver version 2.11.3, starting wxPropView the first time, the so called Quick Setup Wizard will be started. Read more about how to make optimal use of it in the mvIMPACT Acquire GUI manual: https://www.matrix-vision.com/manuals/SDK_GUI_Tools/index.html